hi,
im trying to setup vyatta cluster and almost i did it but i run into situation which i cannot solve for couple of hours. Two vyatta routers:
- vyatta-yin-gw
- vyatta-yang-gw
As per status report from below, router:
- vyatta-yin-gw (secondary) see vyatta-yang-gw (primary) as down (which is not the case)
- vyatta-yang-gw (primary) see vyatta-yin-gw (secondary) as active and in standby (which is the case)
PING works in both ways. Anybody can give some advise, direction toward solution?
=== Status report on secondary node vyatta-yin-gw ===
Primary vyatta-yang-gw: Down
Secondary vyatta-yin-gw (this node): Active
Monitor 89.x.x.x: Reachable
Resources [192.168.5.100/24/eth0 192.168.1.5/24/eth1]:
Active on secondary vyatta-yin-gw (this node)
=== Status report on primary node vyatta-yang-gw ===
Primary vyatta-yang-gw (this node): Active
Secondary vyatta-yin-gw: Active (standby)
Monitor 109..x.x.x: Reachable
Monitor 173..x.x.x: Reachable
Resources [192.168.5.100/24/eth0 192.168.1.5/24/eth1]:
Active on primary vyatta-yang-gw (this node)
Thanks and regards,
Ivan
