Hi,
Am struggling to get a new Ruckus installation going properly, I'm not sure about the VLAN config and the terminology used. I'm not an expert in VLANs and networking, I have a basic understanding. This new installation is replacing an old one and we have got the new APs in the same switch ports as the old ones were in, for the most part.
The scenario is I have 3 subnets for wifi usage on separate VLANS, they are:
10.1.1.0 - VLAN 10 - Wireless
10.1.2.0 - VLAN 20 - Wireless Guests
10.1.3.0 - VLAN 30 - Wireless BYOD
Then an additional VLAN to consider here is the management VLAN (which the Ruckus Zone Director is on and the network switches are on, and I intended to get all the APs on this VLAN as well).
10.1.4.0 - VLAN 40 - Management (Ruckus ZD has a DHCP reservation of 10.1.4.20)
The switching environment is HP ProCurve. So I need to...